用MFR造句子，“MFR”造句

6、The influences of different initiators and their concentrations on grafting ratio and the melt flow rate (MFR ) of the grafted polymer were studied.

9、By testing the MFR of silane grafted PE with different preservation time, and the surface condition and the gel content of the silane grafted extrudates with different retention time in extruder.

12、通過熔體流動速率(MFR)、擠出脹大比(SR)以及動態流變數據等表徵方法，研究了退火工藝對剪切改*樣品流變*能的回覆作用。

2、The result of MFR showed that the compounded fire-retardant with 40 PHR could meet the needs of processing craftwork.

5、The results show that the tensile strength, breaking elongation, impact strength and MFR of nylon 6 increase simultaneously after some PAMAM were added. The optimum increment is 1.0%.

10、熔體流動速率(MFR)的測定表明當複合阻燃劑的添加量為40份時，仍能滿足加工工藝的要求。

1、OBJECTIVE: to observe the protection of the effective fraction of Hibiscus Mutabilis L. (MFR) on renal ischemic reperfusion injury in rats to probe into the mechanism of MFR on anti inflammation.

7、Even though MFR values are measured at an unrealistically low shear rate, it might seem that the test would accurately rank different materials for comparative ease of flow.

13、實驗結果表明：產物的接枝率和熔體流動速率（MFR）變化與聚乙烯的種類有直接關係，接枝*能從優到差的順序為： LDPE>LLDPE>HDPE；

8、研究了引發劑種類及用量對接枝率和接枝物熔體流動速率（MFR）的影響。

4、There are several models for the problem: Minimum Fragment Removal (MFR) problem, Minimum SNP Removal (MSR) problem, and Minimum Error Correction (MEC) problem.

11、實驗結果表明：產物的接枝率和熔體流動速率（MFR）變化與聚乙烯的種類有直接關係，接枝*能從優到差的順序為：LDPE>LLDPE>HDPE；

3、MFR did not take the models too literally and was one of the few firms to have been appropriately pessimistic.